Several service primitives include a parameter vector. This vector is a list of parameters that may vary depending on the PHY type. Table 8-4 lists the minimum parameter values required by the MAC or PHY in each of the parameter vectors.
いくつかのサービスプリミティブはパラメータベクトルを含む。
このベクトルはPHYの種類によって一覧にされる。
次の表はそのなかでも最低限のパラメータを示す。
いくつかのサービスプリミティブはパラメータベクトルを含む。
このベクトルはPHYの種類によって一覧にされる。
次の表はそのなかでも最低限のパラメータを示す。
Parameter | Associated vector | Value |
---|---|---|
DATARATE | TXVECTOR, RXVECTOR | PHY dependent. The name of the field used to specify the Tx data rate and report the Rx data rate may vary for different PHYs. |
LENGTH | TXVECTOR, RXVECTOR | PHY dependent ACTIVE_RXCHAIN_SET PHYCONFIG_VECTOR The ACTIVE_RXCHAIN_SET parameter indicates which receive chains of the available receive chains are active. |
OPERATING_CHANNEL | PHYCONFIG_VECTOR | The operating channel the PHY is configured use. |
SECONDARY_CHANNEL_OFFSET | PHYCONFIG_VECTOR | Enumerated type: SECONDARY_CHANNEL_NONE indicates operation in 20 MHz HT STAs. SECONDARY_CHANNEL_ABOVE indicates operation in 40 MHz with the secondary channel above the primary. SECONDARY_CHANNEL_BELOW indicates operation in 40 MHz with the secondary channel below the primary. |
ANT_CONFIG | PHYCONFIG_VECTOR | Indicates which antenna configuration(s) is to be used when receiving packets and which configuration is to be used when switching configurations during the reception of a packet. Values are implementation dependent. |
GROUP_ID_MANAGEMENT | PHYCONFIG_VECTOR | Specifies membership status and STA position for each of the group IDs as described in 9.6.23.3 |
PARTIAL_AID_LIST_GID00 | PHYCONFIG_VECTOR | Includes the list of partial AIDs, of which the STA is an intended recipient, associated with group ID 0. The settings of the PARTIAL_AID are specified in 10.20). |
PARTIAL_AID_LIST_GID63 | PHYCONFIG_VECTOR | Includes the list of partial AIDs, of which the STA is an intended recipient, associated with group ID 63. The settings of the PARTIAL_AID are specified in 10.20). |
LISTEN_TO_GID00 | PHYCONFIG_VECTOR | When true, indicates to the PHY not to filter out PPDUs with GROUP_ID field equal to the value 0. |
LISTEN_TO_GID63 | PHYCONFIG_VECTOR | When true, indicates to the PHY not to filter out PPDUs with GROUP_ID field equal to the value 63. |
コメントをかく